Can You Weld Galvanized Steel? Fumes and Safe Method
Yes, galvanized steel can be welded with MIG, stick or flux-core, but the zinc coating burns into fumes that can cause metal fume fever. Grind the zinc off the weld area first, weld in open air or with fume extraction, wear a respirator suitable for welding fumes, and treat the bare weld with zinc-rich paint afterward.
Welding galvanized steel step by step
- Work outdoors or with fume extraction. Keep your head out of the plume.
- Grind or sand the zinc off the joint and a band of about an inch on each side, down to bright steel.
- Fit the joint well. A gap makes the weld pool boil through remaining zinc.
- Choose the process. Flux-core and stick tolerate light coatings. MIG with gas works if the zinc is removed. See flux core vs MIG and types of welding.
- Weld a bit slower than on bare steel, so zinc vapor can escape the pool. Test on scrap first.
- Brush off slag and spatter, then paint the bare area with zinc-rich cold galvanizing paint.
Why zinc is a problem
Zinc boils at a lower temperature than steel melts, so the coating vaporizes in the arc. The fumes can cause metal fume fever, with flu-like symptoms. The vapor can also cause porosity in the weld, which weakens it. For the weld defects to look for, see good vs bad welds.
Protective gear
- A respirator rated for welding fumes, fitted as the maker describes.
- A helmet, gloves and a jacket; see welding helmets and welding gloves.
- Good ventilation, or a fume extractor at the arc.
Related
Weld-through primers also contain zinc; see weld-through primer. For general rules, see welding safety tips.
Safety
Don’t weld galvanized tanks or containers that held fuel or chemicals. Stop and get fresh air if you feel dizzy or sick, and see a doctor if symptoms are severe.
Frequently asked questions
Is it safe to weld galvanized steel?
It can be done safely with precautions. The danger is the zinc fume, which can cause metal fume fever, with flu-like symptoms. Remove the coating where you can, ventilate well and wear a respirator.
Do I need to remove galvanizing before welding?
Removing it from the weld area is the best practice. It reduces fumes and porosity, and gives a stronger weld.
What are the symptoms of zinc fume exposure?
Fever, chills, nausea, headache and a metallic taste, usually within hours of exposure. They normally pass in a day or two, but get medical advice if they are severe.
How do I protect the weld from rust afterward?
Clean off slag and spatter, then apply a zinc-rich cold galvanizing paint to the bare weld area.
Related guides
- Guide
Welder Generators: What Size Generator to Run a Welder
What size generator runs a welder: how to read the welder's input amps and volts, running vs surge watts, inverter generators and engine-driven welders.
- Guide
Welding Magnets: Types, Angles and Holding Force
Welding magnets compared: arrow, switchable and adjustable-angle types, 45, 90 and 135 degree holds, holding force ratings, heat limits and how to use them.
- Guide
Oxy-Acetylene Torch: Setup, Flame Types and Safety
Oxy-acetylene torch setup: regulators, hoses and flashback arrestors, the neutral, carburizing and oxidizing flames, and the safety rules for cylinders and use.