Welding Magnets: Types, Angles and Holding Force
Welding magnets hold steel pieces at set angles, usually 45, 90 and 135 degrees, so you can tack them without clamps. The main types are fixed-angle arrow magnets, switchable magnets and adjustable-angle magnets. Check the holding force rating, and keep magnets away from heat, because heat weakens them. They hold only steel and iron, not aluminum or stainless.
Welding magnet types at a glance
| Type | Angles | Good for | Notes |
|---|---|---|---|
| Arrow (fixed angle) | 45, 90, 135 degrees | Corners, frames, flat joints | Cheap and simple |
| Switchable | Fixed angles | Easy release after tacking | Turn off with a switch to remove |
| Adjustable angle | A range, set with a pivot | Odd angles | Check the pivot holds under load |
| Square or V-pad | 90 degrees or round stock | Tube and bar | Fits round work |
Choosing one
- Pick the angles you need. The 45, 90 and 135 degree set covers most frames.
- Check the holding force rating against the weight of the pieces.
- Look at the face. Flat faces hold plate, and V faces hold tube.
- Prefer switchable types if you remove magnets often.
How to use them
- Clean rust and paint from where the magnet sits, so it grips.
- Place the magnets on both sides of the joint at the angle you want.
- Check the fit with a square, then tack the joint.
- Remove the magnets before the work is hot, then weld the joint fully.
Magnets can also pull the arc off line, a problem called arc blow. If the arc wanders, move the magnet or clamp instead. For more on fit-up, see welding tables and welding tools for a home shop.
When to use clamps instead
Aluminum and stainless need clamps. For thick, heavy parts, use clamps or fixtures. See beginner welding setup for a starter kit.
Safety
Keep magnets away from heat, pacemakers, phones and cards. Wear gloves, because magnets can pinch fingers when they snap on.
Frequently asked questions
What do welding magnets hold?
Steel and iron that a magnet sticks to. They do not hold aluminum or most stainless steel.
What holding force do I need?
Common ratings run from about 25 to 100 lb. Choose one rated above the weight of your workpiece. The rating is measured on thick, clean, flat steel, so a thin, rusty or painted surface holds less.
Do welding magnets lose strength?
Yes. High heat weakens them, so keep them away from the weld area and don't put them in a fire. Hard knocks also reduce strength.
Are welding magnets safe near a pacemaker?
Strong magnets can interfere with a pacemaker or other implants. Check with your doctor and the maker's warnings.
Related guides
- Guide
Plug Weld vs Spot Weld: How to Make a Plug Weld
Plug weld vs spot weld: how each joins overlapping sheet, when to use a plug weld with a MIG welder, hole size, step by step, and how to check the result.
- Guide
Welding Rod Sizes and Amperage Chart
Welding rod sizes and amperage chart for 6013 and 7018 stick rods, with the metal thickness each size suits, how to read the rod number, and how to set amps.
- Guide
Spot Weld Cutter: How to Drill Out Spot Welds
What a spot weld cutter is, how to drill out spot welds to remove a panel without bending it, which bits to use, and how to avoid cutting the lower sheet.