Spot Weld Cutter: How to Drill Out Spot Welds
A spot weld cutter is a hollow or center-pin drill bit that cuts out the top sheet of a spot weld so the panel can be separated without damaging the metal below. Mark the weld, drill through the top sheet only at low speed with cutting oil, then pry the panel free and grind the leftover nub.
Ways to remove a spot weld
| Method | How it works | Notes |
|---|---|---|
| Spot weld cutter (rotary) | Cuts a disc from the top sheet | Cleanest, keeps the lower panel flat |
| Spot weld drill bit | Twist or step bit sized to the weld | Works if the bit is sharp and centered |
| Grinder | Grinds the weld head off | Fast but removes more metal and can mark the panel |
| Chisel | Cuts the weld by impact | Can distort the panel |
How to use a spot weld cutter
- Find the spot welds. Strip paint or sealant to see them.
- Center punch each weld so the bit does not wander.
- Set the drill to low speed and fit the cutter. The pin goes in the center of the weld.
- Apply cutting oil, drill with moderate pressure and cut through the top sheet only. Stop when the disc is free.
- Separate the panels with a wide chisel or panel lifter, then grind or file the remaining nub flat.
The cutter is hard steel, so use a drill that holds speed steadily. A bit that has dulled will glaze the metal, so sharpen or replace it. See drill bits for metal and how to sharpen drill bits. For very hard welds, see cobalt bits for hardened steel.
Tips
- Cut slowly. High speed overheats the bit and hardens the weld.
- Stop as soon as the top sheet breaks free. Don’t drill into the lower panel.
- Some welds are made of hardened steel, so use cobalt or carbide-tipped cutters on those.
- Check the repair guide for the vehicle for the weld position.
Rejoining the panel
New panels can be plug welded where the old ones were spot welded. See plug weld vs spot weld.
Safety
Wear safety glasses, gloves and hearing protection. Clamp the work, and remove fuel and flammable materials near the area.
Frequently asked questions
What is a spot weld cutter?
A drill bit made to remove spot welds. It cuts a round disc from the top sheet so the panels separate, and it usually has a center pin that keeps it on the weld.
What size spot weld cutter do I need?
Common sizes are about 3/8 to 1/2 in, to suit the weld. Pick one slightly larger than the weld nugget.
Can I use a normal drill bit to remove a spot weld?
You can drill the weld out with a sharp, strong bit, but a spot weld cutter stays centered and cuts a clean disc, so it is easier on the lower panel.
Why does the cutter wander off the weld?
Because the weld is hard and the surface is smooth. Center punch the weld, use the pin and start at slow speed.
Related guides
- Guide
Plug Weld vs Spot Weld: How to Make a Plug Weld
Plug weld vs spot weld: how each joins overlapping sheet, when to use a plug weld with a MIG welder, hole size, step by step, and how to check the result.
- Guide
Welding Rod Sizes and Amperage Chart
Welding rod sizes and amperage chart for 6013 and 7018 stick rods, with the metal thickness each size suits, how to read the rod number, and how to set amps.
- Guide
Welding Boots and Caps: What to Wear Head to Toe
What to wear for welding from head to toe: leather boots, trousers over the boots, welding caps, gloves and jacket, and what to avoid so sparks stay out.