Plug Weld vs Spot Weld: How to Make a Plug Weld

A spot weld fuses two overlapping sheets at a point using a resistance spot welder, with no hole. A plug weld is made by drilling a hole in the top sheet and filling it with weld metal so it fuses to the sheet below. A plug weld needs only a MIG welder and suits repairs where a spot welder cannot reach.

Plug weld vs spot weld

FeatureSpot weldPlug weld
How it is madeElectrodes squeeze the sheets and pass currentArc fills a hole in the top sheet
EquipmentResistance spot welderMIG welder (or other arc process)
Hole in top sheetNoYes
AccessNeeds both sides for the electrodesNeeds the top side only
Typical useFactory body assemblyRepair, replacement panels

For how to judge the finished weld, see good vs bad welds.

How to make a plug weld

  1. Clean the sheets to bare metal. If the overlap faces need rust protection, use a weld-through coating; see weld-through primer.
  2. Drill or punch holes in the top sheet, about 5/16 to 3/8 in on thin sheet, spaced as the panel’s original spot welds were.
  3. Clamp the panels flat with no gap. Gaps cause burn-through and weak welds.
  4. Set the MIG welder for the sheet thickness and test on scrap. See what is MIG welding and shielding gas for MIG.
  5. Start the arc on the bottom sheet at the edge of the hole, then swirl around and fill the hole to the top, using short pulses of the trigger.
  6. Let it cool, then grind flush if needed and treat the panel for rust.

Checking the weld

A good plug weld is round, fused all around the hole’s edge and slightly proud of the surface. Check for burn-through, holes and a cold, rounded edge that did not fuse. Test your settings on scrap by pulling the pieces apart.

Safety

Wear a helmet, gloves and a jacket. See welding safety tips. Remove fuel and flammable materials from the area before you weld on a vehicle.

To take an old panel off first, see how to drill out spot welds.

Frequently asked questions

What is the difference between a plug weld and a spot weld?

A spot weld is made by squeezing sheets between electrodes and passing current, so the metal melts at the contact. A plug weld is made with an arc through a hole punched or drilled in the top sheet.

What size hole for a plug weld?

A common size on thin sheet is about 5/16 to 3/8 in. Follow the repair spec if there is one, and use a larger hole on thicker sheet.

Can I plug weld with a MIG welder?

Yes. A MIG welder is the usual tool for plug welding in body repair. Use the settings for the sheet thickness and a clean joint.

Is a plug weld as strong as a spot weld?

A well-made plug weld can match a spot weld in a repair, but it depends on fit-up, penetration and clean metal. Check the panel maker's repair guidance.

Report a mistake on this page