Shielding Gas for MIG: 75/25, 100% CO2 and Argon

For mild steel with solid wire, use 75/25 (75% argon, 25% CO2) for a smooth arc and little spatter, or 100% CO2 for deeper penetration at lower cost and more spatter. Use pure argon for aluminum and a stainless blend for stainless. Flow is typically 15 to 25 cubic feet per hour. Self-shielded flux-core wire needs no gas.

MIG shielding gas at a glance

GasMetalEffect on the weld
75% argon / 25% CO2Mild steelSmooth arc, low spatter, neat bead, moderate penetration
100% CO2Mild steelDeeper penetration, harsher arc, more spatter, cheaper
100% argonAluminumClean, stable arc; also used for TIG
Argon with a small amount of CO2 or oxygen (stainless blend)Stainless steelKeeps the weld clean and corrosion resistant

Makers sell several blends, so use the wire maker’s recommendation for the exact gas. The gas supply is one of the core parts listed in what is MIG welding.

Which gas for which job

  • Thin sheet and car panels on steel: 75/25, because it spatters less and burns through less.
  • Thick steel where penetration matters and cleanup is fine: CO2.
  • Aluminum: argon, with aluminum wire and a spool gun or push-pull gun. See types of welding for how the processes differ.
  • Stainless: a stainless blend with stainless wire, as in welding stainless steel.

Flow rate and setup

  1. Set the regulator flow to about 15 to 25 CFH.
  2. Check the hose and nozzle for leaks and spatter build-up. A blocked nozzle disturbs the gas.
  3. Keep the nozzle close to the work, and weld out of drafts. Wind blows the gas away, which is why outdoor welding favors flux-core. See flux core vs MIG.
  4. Close the cylinder valve when you finish.

Safety

Chain or strap gas cylinders upright, and keep the cap on when you move one. Weld in a ventilated space, because shielding gases can displace air in small rooms. See welding safety tips.

Frequently asked questions

What is 75/25 welding gas?

A mix of 75% argon and 25% carbon dioxide. It is the most common MIG gas for mild steel because it gives a stable arc, low spatter and a neat bead.

Can I use 100% CO2 for MIG welding?

Yes, on steel. It penetrates deeper and costs less, but the arc is harsher and spatter is higher. It is not suitable for aluminum.

What gas do I use for aluminum MIG?

Pure argon. CO2 mixes make aluminum welds dirty and porous.

What flow rate should I set?

Typically 15 to 25 cubic feet per hour (CFH) indoors. Raise it a little in light drafts, but too much gas causes turbulence and porosity.

Do I need gas for flux-core?

Not for self-shielded flux-core wire. Gas-shielded flux-core wire does need gas, usually CO2 or 75/25, as the wire maker states.

Report a mistake on this page