Weld-Through Primer: When to Use It and How to Weld

Weld-through primer is a zinc-rich coating applied to the mating surfaces of lap joints and of spot and plug welds, so the hidden metal does not rust, and it is made to be welded through. Apply a thin coat to bare metal, let it dry as the label says, weld the joint, then grind and paint the outside. Work in a ventilated area, because the zinc makes fumes.

Where weld-through primer is used

  • Lap joints and flanges where two panels overlap.
  • Spot welds and plug welds in body repair.
  • Seams in frames, trailers and sheet metal fabrication.

The zinc gives some corrosion protection to the inner faces that nobody can reach with paint after welding. For plug and spot welds, see good vs bad welds for how to judge the weld.

How to apply and weld through it

  1. Clean the metal to bare steel with a grinder or wire brush, and remove oil and rust.
  2. Apply a thin, even coat of weld-through primer to the surfaces that will touch. Don’t coat the area where you will weld the outside edge.
  3. Let it dry or cure as the label states.
  4. Clamp the pieces together and weld. MIG and spot welding are common. Test on scrap first and adjust current or wire speed.
  5. Expect more spatter and smoke than on bare metal. Slow down slightly if the weld looks porous.
  6. After welding, grind the weld flush, clean the surface and prime and paint the outside.

What to avoid

  • Using ordinary paint or primer in place of weld-through primer.
  • Coating thickly. A heavy coat causes porosity.
  • Welding without ventilation.
  • Skipping a test weld on scrap.

Safety

Zinc fumes can cause metal fume fever, with flu-like symptoms. Weld outdoors or with local exhaust, keep your face out of the plume and wear a respirator suitable for welding fumes. See welding safety tips and welding helmets, and for wire-feed setup, see what is MIG welding.

Frequently asked questions

What is weld-through primer used for?

Protecting overlapping panels and seams from rust where paint cannot reach, such as car body repair panels, flanges and spot-welded or plug-welded joints.

Can I weld through any primer?

No. Only primers sold as weld-through are made for it. Ordinary primer and paint burn off, create porosity and weak welds.

Is weld-through primer dangerous?

It contains zinc, and welding zinc-coated metal produces fumes that can cause metal fume fever. Weld in a ventilated place and use a respirator suitable for welding fumes.

Does weld-through primer make weaker welds?

A thin coat on a well-fitted joint can be welded, but a thick coat can cause porosity and spatter. Apply it thinly, and test a weld on scrap first.

Report a mistake on this page