Panel Saw: Hand Panel Saw vs Vertical Panel Saw
Panel saw means two different tools. A hand panel saw is a handsaw with a 20 to 26 in blade, used to cut boards and sheet, and it comes with rip teeth for cutting along the grain or crosscut teeth for across it. A vertical panel saw holds a sheet upright and guides a circular saw on a frame to cut plywood and MDF straight and square.
Hand panel saw vs vertical panel saw
| Feature | Hand panel saw | Vertical panel saw |
|---|---|---|
| What it is | A handsaw | A frame that holds a sheet and guides a circular saw |
| Power | Your arm | Circular saw or built-in saw |
| Cuts | Boards and thin sheet | Full sheets of plywood, MDF and similar |
| Size | Blade about 20 to 26 in | Frame sized for 4 x 8 ft sheets |
| Best for | Small jobs, no power | Breaking down sheets in a small shop |
Hand panel saws
A hand panel saw has a flat, tapered blade with a handle at one end. The teeth decide what it cuts best.
| Tooth type | TPI | Cuts |
|---|---|---|
| Rip | About 5 to 7 | Along the grain, fast and rough |
| Crosscut | About 8 to 12 | Across the grain and sheet goods, finer |
For more on handsaws, see hand saw types. For short, fine cuts in joinery, a smaller saw suits better; compare coping saws.
To use one, mark the line, start the cut with short strokes on the waste side, then use long, even strokes and let the saw do the work.
Vertical panel saws
A vertical panel saw stands the sheet on its edge and runs a circular saw down a guide, so cuts come out straight and square. It saves floor space and lifting. For circular saw basics, see circular saw guide.
Which to buy
- For occasional cuts and no power, buy a crosscut hand panel saw.
- For cutting lots of plywood or MDF sheets in a small space, consider a vertical panel saw.
Safety
Wear eye and hearing protection with power saws, and a dust mask when cutting MDF. Clamp the work and keep your hands clear of the blade path.
Frequently asked questions
What is a panel saw?
Either a handsaw for cutting boards and sheet goods by hand, or a vertical frame that guides a circular saw through full sheets of plywood. Check which one a listing means.
What TPI is a hand panel saw?
Rip panel saws are about 5 to 7 TPI, and crosscut panel saws are about 8 to 12 TPI. Higher TPI cuts finer and slower.
Is a vertical panel saw better than a table saw for plywood?
For full 4 x 8 ft sheets in a small shop, often yes. You lean the sheet against the frame instead of lifting it onto a table, and the saw cuts straight. A table saw gives more cut types.
What blade length is a hand panel saw?
Typically 20 to 26 in. A longer blade makes longer strokes and faster cuts but is harder to control.
Related guides
- Guide
Dovetail Saw: TPI, Rip vs Crosscut Teeth
Dovetail saw explained: the fine backsaw for cutting dovetails, typical 14 to 20 TPI, rip vs crosscut teeth, blade length and how to saw to a line.
- Guide
Chop Saw vs Table Saw: Differences and Combo Setups
Chop saw vs table saw compared by cuts, accuracy, size and cost, plus how a chop saw and table saw combo setup works and which one to buy first.
- Guide
Reciprocating Saw Blades: TPI, Length and Which to Use
How to choose a reciprocating saw blade by material: TPI for wood, nailed wood, metal and pruning, blade length, bi-metal vs carbide, and cutting tips.