Dovetail Saw: TPI, Rip vs Crosscut Teeth
A dovetail saw is a small, fine-toothed backsaw with a stiffening spine, used to cut dovetail joints and other precise joinery by hand. Typical blades are 8 to 10 in long with about 14 to 20 TPI. Rip-filed teeth cut fastest along the grain, and crosscut teeth leave a cleaner cut across it.
Dovetail saw at a glance
| Feature | Typical value |
|---|---|
| Blade length | About 8 to 10 in |
| TPI | About 14 to 20 |
| Teeth | Rip filed (common) or crosscut |
| Spine | Brass or steel, stiffens the blade |
| Handle | Open or closed, often straight or pistol grip |
| Used for | Dovetails, small tenons, fine joinery |
Makers differ, so check the label for the TPI and the tooth type.
Rip vs crosscut teeth
Rip teeth are filed like tiny chisels, and they shave along the grain, which is where most dovetail cuts run. Crosscut teeth are filed like knives, and they sever fibers across the grain for a cleaner edge. Fine teeth leave a smoother cut but cut slowly. For tooth counts on other saws, see hand saw types and hacksaw TPI.
How to cut with one
- Mark the line with a marking knife, and clamp the work in a vise.
- Start the cut at the far corner with a light, backward stroke on the waste side of the line.
- Lower the saw to level and use long, light strokes. Let the teeth do the work.
- Cut to the depth line, and stop. The spine will often touch the work at that depth.
- Check the cut against the line, and clean the joint with a chisel.
Tips
- Keep the saw sharp. A dull saw wanders and tears the edge.
- Saw on the waste side of the line, and leave the line.
- Don’t force it. Pressure bends the blade.
Related saws
For curved cuts, see coping saws. For small cuts in metal, see hacksaws.
Safety
Clamp the work and keep your off-hand clear of the blade path. Wear safety glasses.
Frequently asked questions
What TPI is a dovetail saw?
Usually about 14 to 20 TPI. Finer teeth give a cleaner, slower cut, and coarser teeth cut faster.
Is a dovetail saw rip or crosscut?
Most dovetail saws are filed rip, because dovetail cuts run along the grain. Crosscut dovetail saws also exist and suit hardwood and cross-grain cuts.
What is the difference between a dovetail saw and a tenon saw?
A dovetail saw is smaller and finer, for delicate joints. A tenon saw is bigger and coarser, for larger joints.
What does the spine do?
The metal or brass spine along the back stiffens the thin blade, so it cuts straight. It also limits cutting depth.
Related guides
- Guide
Panel Saw: Hand Panel Saw vs Vertical Panel Saw
Panel saw explained: the hand panel saw with rip or crosscut teeth, the vertical panel saw for plywood sheets, how they differ, sizes, TPI and which to buy.
- Guide
Chop Saw vs Table Saw: Differences and Combo Setups
Chop saw vs table saw compared by cuts, accuracy, size and cost, plus how a chop saw and table saw combo setup works and which one to buy first.
- Guide
Reciprocating Saw Blades: TPI, Length and Which to Use
How to choose a reciprocating saw blade by material: TPI for wood, nailed wood, metal and pruning, blade length, bi-metal vs carbide, and cutting tips.