How to Drill Into Stucco Without Cracking It

Drill stucco with a carbide-tipped masonry bit in a hammer drill, starting slow with the hammer off, then switching it on once the bit bites. Mark the spot with tape, stay well away from edges and cracks, and stop when the bit breaks through to the sheathing. Seal the hole with exterior caulk so water cannot get in.

What you need

ItemNotes
Carbide-tipped masonry bitSized to the anchor or screw
Hammer drillOr a regular drill for thin, soft coats
Painter’s tapeMarks the spot and reduces chipping
Stud finder or tape measureFinds the framing behind the wall
Exterior sealantSeals the hole afterward

For the choice of bit, see masonry drill bits for concrete and brick. For a drill that handles it, see hammer drills.

How to drill

  1. Decide what you are fixing. For light items such as a hook or sign, a plastic anchor is enough. For heavy items, find the framing with a stud finder and fix into it, since stucco alone is not a strong anchor.
  2. Mark the spot with tape, and keep at least a couple of inches from edges, corners and cracks.
  3. Fit the bit and check its depth against the stucco coat and anything behind it.
  4. Start at low speed with the hammer off, so the bit grips without skating.
  5. Switch the hammer on once the bit has started, and drill with steady, light pressure.
  6. Clear dust and stop when the bit breaks through the stucco to the sheathing or lath. Metal lath behind the coat will stop a masonry bit, so switch to a metal bit if you hit it. See drill bits for metal.

Avoiding cracks

  • Use a sharp bit. A dull bit needs more force, and force cracks stucco.
  • Keep the hammer setting off for the first few seconds.
  • Don’t lean on the drill. Let the bit cut.
  • Predrill a small hole first, then step up in size for larger holes.

Sealing the hole

Fit the anchor or screw, then run exterior sealant around it. Water that gets behind stucco can damage the wall and cause rot. Recheck the seal each year.

Safety

Wear safety glasses and a dust mask, since stucco dust contains silica. Check for pipes and wires in the wall before you drill.

Frequently asked questions

What drill bit do I use for stucco?

A carbide-tipped masonry bit. For small holes, a standard round-shank masonry bit works. For larger holes, use SDS-plus bits in a rotary hammer.

Do I need a hammer drill for stucco?

A hammer drill is faster and cleaner on hard stucco. A regular drill works on thin, soft coats if you go slowly with a sharp masonry bit.

Why does stucco crack when I drill it?

Stucco is hard and brittle. Heavy pressure, a dull bit or a hole too near an edge or an existing crack makes it chip or crack.

What do I do after drilling into stucco?

Seal around the fixing with exterior-grade sealant so water cannot enter. Water behind stucco can cause rot and mold.

Report a mistake on this page