Hole Saw Arbor: Sizes and How to Fit One
A hole saw arbor is the shank that holds the saw cup and fits the drill chuck. Most hole saws use two sizes: a small arbor for cups from about 9/16 to 1-1/4 in and a large arbor for cups from 1-1/4 to 6 in. Check the arbor’s thread and shank, since the cup must screw on and the shank must fit your chuck.
Arbor sizes at a glance
| Arbor | Cup range | Shank | Notes |
|---|---|---|---|
| Small | About 9/16 to 1-1/4 in | Usually 3/8 in or hex | Takes a 1/4 in pilot bit |
| Large | About 1-1/4 to 6 in | Usually 3/8 in, 7/16 in hex or 1/2 in | Often the 5/8-18 thread |
| Quick-change | Varies by system | Hex or round | Needs matching cups |
| Extension | Same as the large arbor | Longer shank | For deep cuts and tight spots |
Makers differ, so the maker’s chart settles the exact fit. The basics of arbors are in hole saw sizes.
How to match an arbor
- Read the cup size, then pick the arbor the maker lists for that range.
- Check the arbor thread against the cup, since many large cups use a 5/8-18 thread.
- Check the shank against your chuck. Many drills take 3/8 in or 1/2 in shanks; see the drill chuck size guide.
- Check the pilot bit length so it sticks out past the teeth.
How to fit and remove a cup
- Screw the cup onto the arbor until it seats against the shoulder, or until the drive pins line up with the cup holes.
- Tighten the arbor in the chuck, checking for wobble.
- After the cut, unscrew the cup and push the core out through the side slots, or use a screwdriver to pry it free.
If a cup sticks, reverse the drill slowly or loosen it with pliers before pulling the core. The cutting steps are in hole saw sizes guide.
Safety
Clamp the work, wear safety glasses, and hold the drill with both hands. A hole saw can grab and twist the drill, so use the side handle on big cups.
Frequently asked questions
What does a hole saw arbor do?
It connects the saw cup to the drill. A pilot bit in the middle keeps the cup centered, and the arbor locks into the chuck.
Do all hole saws fit all arbors?
Not always. Many large cups use a 5/8-18 thread, but makers also sell quick-change and proprietary systems. Match the arbor to the cup system.
What size arbor do I need?
Use the small arbor for small cups and the large arbor for cups above about 1-1/4 in. Check the maker's chart for the cup range each arbor supports.
What is a quick-change arbor?
An arbor that lets you swap cups without unscrewing them, by pulling a collar or pressing a button. It is faster but works only with the matching cups.
Related guides
- Guide
Diamond Hole Saws: Tile, Glass and Stone
What a diamond hole saw is, which sizes and types suit tile, glass, porcelain and stone, how to use one wet, and how it differs from a regular hole saw.
- Guide
How to Drill Glass: Bottles, Mirrors and Glass Sheets
The bit to use for glass, how to start the hole, how to keep it cool, and how to drill bottles, mirrors and thick glass without cracking them.
- Guide
How to Sharpen a Drill Bit: Angles and Methods
How to tell a drill bit is dull, the 118° and 135° point angles, lip relief, and how to sharpen a twist bit by hand, on a grinder or with a sharpener.