Chainsaw Chain Types: Full Chisel vs Semi-Chisel

Full chisel chain cuts fastest in clean wood but dulls quickly and kicks back harder. Semi-chisel chain cuts a little slower and stays sharp longer in dirty or frozen wood. Low-profile and low-kickback chains are the safer choice for homeowners and light saws. Whatever the type, the chain’s pitch, gauge and drive link count must match the bar and the saw.

Chainsaw chain types at a glance

ChainCutter shapeCutting speedHolds an edgeBest for
Full chiselSquare cornersFastestDulls fast if it hits dirtClean wood, felling, experienced users
Semi-chiselRounded cornersSlightly slowerLonger, more forgivingFirewood, dirty or frozen wood, general use
Low-profile (3/8 in LP)Small cutters, low kickbackModerateGoodHomeowner and battery saws
Low-kickbackGuard or bumper linksModerateGoodBeginners, pruning, light saws

Makers use their own names for these, so check the chain’s packaging for how it is described.

Full chisel chain

Full chisel cutters have square corners that slice the fibers and clear a lot of wood. They cut fastest, but the sharp corner dulls quickly if it touches dirt, and the chain demands more care when sharpening. It also kicks back harder than the others, so it is for experienced users in clean wood.

Semi-chisel chain

Semi-chisel cutters have rounded corners, which are tougher and more forgiving. They hold their edge longer in dirty, frozen or knotty wood and are easier to sharpen with a round file. That makes semi-chisel the usual choice for firewood and general work.

Low-profile and low-kickback chains

Low-profile chains, such as 3/8 in low profile, are used on many homeowner and battery saws. The small cutters make a narrow cut and need less power. Low-kickback chains have a guard link or bumper drive link ahead of each cutter that limits how deep it can bite, which reduces the chance of a violent kickback. Light saws and pole saws often use them; see pole saws.

Matching a chain to your saw

A chain fits only if three numbers match the bar and the sprocket:

  • Pitch: the spacing of the rivets.
  • Gauge: the thickness of the drive links.
  • Drive link count: the number of links that run in the bar groove.

These are usually stamped on the bar near the saw body. How to measure a chainsaw bar and chain shows how to read them, and 16 vs 18 inch chainsaw bars covers the bar length.

Sharpening different chains

The file size follows the chain’s pitch, and the angle follows the marks on the chain’s cutters. Full chisel and semi-chisel chains use similar angles, often around 30°, but check the chain’s markings. See how to sharpen a chainsaw for file sizes and the step-by-step method. A well-lubricated chain stays sharp longer; see chainsaw bar oil.

Safety

Wear chaps, gloves, eye and ear protection and a helmet when using a chainsaw. Keep the chain sharp, because a dull chain forces you to push and is more likely to kick back.

For rough, dirty or frozen wood, see carbide chainsaw chain.

Frequently asked questions

Which chainsaw chain is best for firewood?

Semi-chisel chain, because it holds an edge better in bark, dirt and knots. Full chisel cuts faster, but dulls quickly if it touches the ground.

What is a low-kickback chain?

A chain with guard links or bumper drive links ahead of each cutter, which limit how deep the cutter can bite and reduce the chance of kickback. It cuts a little slower than a full chisel chain.

Can I put any chain on my chainsaw?

No. The pitch, gauge and drive link count must match the bar and the saw's sprocket. Check the numbers stamped on the bar or on the old chain.

Does a chain type affect the file size?

The file size depends on the pitch, not the type. The sharpening angle can depend on the chain type, so follow the markings on the chain or the maker's instructions.

Report a mistake on this page