Can You Use Used Motor Oil for Chainsaw Bar Oil?

Used motor oil isn’t a good substitute for chainsaw bar oil. Bar and chain oil contains a tackifier that makes it cling to the chain as it whips around the bar; motor oil doesn’t, so much of it flies off and the bar and chain run drier and wear faster. Used oil also carries fine metal particles, soot and acids from the engine, which act like a grinding paste on the bar groove, the sprocket and the oil pump, and chainsaw makers generally say to use only bar and chain oil. Whatever is in the oil also ends up sprayed on the ground and on you.

Bar oil vs used motor oil

Bar and chain oilUsed motor oil
Tackifier (stays on the chain)YesNo
CleanYesContains metal particles, soot, fuel and acids
Suits the saw’s oil pumpYesContaminants can wear or clog it
Where it ends upOn the ground; biodegradable versions existOn the ground, with its contaminants
WarrantyApprovedOften not allowed by the maker

What to use instead

  • Bar and chain oil: the standard choice. Some makers sell a thinner winter grade and a thicker summer grade.
  • Biodegradable bar oil: vegetable-based (often canola) bar oils are made for chainsaws and are kinder to soil and water near gardens and streams.
  • In an emergency: clean, new motor oil keeps a chain lubricated for a short job, but it flings off quickly, so check the oil level more often and switch back to bar oil as soon as you can.

Don’t use used oil, and don’t use thick gear oil in cold weather; it may not flow through the pump.

Keeping the bar and chain lubricated

  1. Fill the oil tank every time you refuel; most saws are designed to use up oil and fuel at about the same rate.
  2. Check that oil reaches the chain: point the running saw at a light surface and rev it; a line of oil spatter should appear.
  3. Clean the bar’s oil hole and groove when you change or sharpen the chain.
  4. Turn up the oiler, if your saw has an adjustment, for longer bars and hardwoods.

If you’re choosing a saw, 16 vs 18 inch chainsaw explains bar lengths; for a saw that won’t start or idle, see aftermarket chainsaw carburetors.

Related guides

Report a mistake on this page