Staple Guns: Manual, Electric and Pneumatic
A staple gun fires U-shaped staples into wood, fabric and sheeting. Manual guns suit light, occasional jobs, electric guns drive faster with less hand strain, and pneumatic staplers suit big jobs and hard wood but need a compressor. Use the staple type and size the gun is made for, and shorter staples for thin material.
Staple gun types at a glance
| Type | Power | Best for | Notes |
|---|---|---|---|
| Manual (squeeze) | Hand | Light jobs, posters, fabric, insulation | Tiring on long jobs |
| Electric | Mains or battery | Upholstery, house wrap, repeated work | Steady, fewer misfires |
| Pneumatic | Air compressor | Flooring, framing, big upholstery jobs | Fastest, needs hose and compressor |
| Hammer tacker | Swing | Roofing felt, house wrap | Fires as you swing |
Pneumatic staplers are sold by staple gauge and crown width, like the nailers in brad vs finish vs pin nailers.
Staple sizes
Staples are described by the crown (the width across the top) and the leg length. Narrow-crown staples suit trim and upholstery, and wide-crown staples suit house wrap, insulation and screen. Check the gun’s label for the exact staple series and the lengths it takes. Pick a leg length that goes through the top material and bites into the base, but does not pierce the far side.
How to use a staple gun
- Load the right staple series and close the magazine.
- Hold the gun flat and square to the work, pressed firm against the surface.
- Fire and check that the staple sits flush. Raise the power or shorten the staple if it stands proud or goes through thin stock.
- Keep fingers clear of the nose, and clear a jam with the gun disconnected from power or air.
Related guides
For flooring work, see flooring nailers, and for roof work see roofing nailers.
Safety
Wear safety glasses. Never point a staple gun at anyone, and disconnect the power or air before you clear a jam. Keep staples away from wires and pipes behind the surface.
Frequently asked questions
What is the difference between a staple gun and a nailer?
A staple gun fires staples with a wide crown for holding fabric, wire and sheet. A nailer drives nails. Pneumatic staplers also exist for framing, flooring and cabinet work.
Which type of staple gun is best for upholstery?
A pneumatic or electric stapler with fine, narrow-crown staples is easiest for repeated work. Manual guns suit small jobs.
Why does my staple gun jam?
Common causes are the wrong staple size, bent staples, a dirty magazine or weak driving on hard wood. Use the right staples and clean the gun.
Can a staple gun go into concrete?
No. Use a concrete nailer or anchors for masonry.
Related guides
- Guide
Concrete Nailer: Powder, Gas and Cordless Types
Concrete nailer types compared: powder-actuated, gas and cordless, what each drives into concrete, block and steel, and the safety rules that apply.
- Guide
Roofing Nailers: Nail Length, Depth and What They Do
What a roofing nailer is, which coil nails it fires, how to choose nail length for shingles, how to set the depth, and how it differs from a framing nailer.
- Guide
Flooring Nailers: Manual vs Pneumatic, Cleats vs Staples
Flooring nailers for tongue-and-groove hardwood: manual vs pneumatic, cleats vs staples, fastener sizes, and how to nail a floor.