Concrete Nailer: Powder, Gas and Cordless Types
A concrete nailer drives hardened pins or nails into concrete, block and steel to fix wood, track or fixtures. The three types are powder-actuated (a small explosive load), gas (a fuel cell and spark) and cordless battery. Powder tools are the strongest, gas and cordless are easier to carry and use, and all need eye and ear protection.
Concrete nailer types at a glance
| Type | How it drives | Best for | Notes |
|---|---|---|---|
| Powder-actuated | A powder load fires the pin | Dense concrete, steel, heavy fixings | Loud, needs loads, training often required |
| Gas-powered | A fuel cell and spark drive a piston | Wood to concrete, track, furring strips | No loads, lighter, needs fuel cells |
| Cordless battery | A battery-driven mechanism | Light fixings, repeated use | Limited power in hard concrete |
| Hand-driven (hammer-set) | A hammer strikes the pin | A few light fixings | Slow, and easy to miss |
Makers rate each tool for the materials and pin lengths it handles. Check the label and the manual for the tool, loads and pins as a set.
What you can fix with one
- Wood plates and furring strips to concrete walls and floors.
- Metal track and channel to concrete or steel.
- Light fixtures and brackets where the maker allows it.
For framing and wood-to-wood work, see framing nailers. For the full range of nail guns, see brad vs finish vs pin nailers.
How to use one
- Choose the tool, pin length and load or fuel cell the maker lists for your base material and fixture.
- Check that the concrete is cured and thick enough. Fresh, thin or cracked concrete can spall.
- Keep fasteners well back from edges and from each other, to the distances the maker gives.
- Press the tool square to the work and fire. Never fire at a hard surface at an angle.
- If a pin bends or fails to set, don’t fire again in the same spot. Move over.
When to use a drill instead
For heavy loads, ledgers and anchors, a hammer drill with concrete screws or anchors holds better and is rated for the load. See drill bits for concrete and hammer drills.
Safety
Wear safety glasses and hearing protection, and keep your hands away from the muzzle. Powder-actuated tools have strict rules on loading, storage and operator training, so read the manual and check what your area requires. Concrete dust contains silica, so wear a dust mask when drilling.
Frequently asked questions
Can a normal nailer shoot into concrete?
No. Brad, finish and framing nailers use soft nails that bend or break on concrete. Concrete work needs hardened pins and a tool made to drive them.
What is a powder-actuated tool?
A tool that uses a small powder load, like a blank cartridge, to drive a pin into concrete or steel. Makers rate the loads by strength, and many places require operator training.
Is a gas concrete nailer better than a powder tool?
Gas and cordless tools are quieter, need no loads and suit light work such as wood furring strips. Powder tools drive harder into dense concrete and steel.
Can I use a hammer drill and anchors instead?
Yes. For heavy loads or where the maker requires it, drill with a hammer drill and fit concrete screws or anchors. A nailer is faster for light fixings.
Related guides
- Guide
Roofing Nailers: Nail Length, Depth and What They Do
What a roofing nailer is, which coil nails it fires, how to choose nail length for shingles, how to set the depth, and how it differs from a framing nailer.
- Guide
Flooring Nailers: Manual vs Pneumatic, Cleats vs Staples
Flooring nailers for tongue-and-groove hardwood: manual vs pneumatic, cleats vs staples, fastener sizes, and how to nail a floor.
- Guide
Can You Use 21 Degree Nails in a 22 Degree Nailer?
Whether 21-degree nails work in a 22-degree framing nailer: why many nailers accept a range of angles, when it jams, and what to check first.