Parts of a Hammer and How to Replace a Handle

A hammer has two main parts: the head and the handle. The head has a face (which strikes), a neck, cheeks and, on a claw hammer, a claw; the handle fits through the eye of the head and is held by a wedge. To replace a handle, remove the broken stub, clean the eye, fit the new handle, drive in the wedge and trim the end.

Parts of a hammer

PartWhat it isJob
HeadThe metal blockDelivers the blow
FaceThe flat or domed striking surfaceStrikes the nail or work
NeckThe narrower part between the face and the eyeTransfers force
CheekThe sides of the headReinforces the eye
ClawCurved or straight fork on a claw hammerPulls nails
EyeThe hole through the headHolds the handle
Handle (shaft)Wood, fiberglass or steelGives leverage and grip
WedgeA small wedge driven into the top of the handleLocks the head to the handle
GripThe covering at the end of the handleComfort and control

Other hammers have different heads: a ball peen has a rounded peen, a cross peen has a wedge-shaped peen and a dead blow hammer has a hollow head filled with shot. See types of hammers.

Handle materials

  • Hickory and ash are the standard wood handles. They absorb shock and are easy to replace.
  • Fiberglass handles are strong and weather-resistant.
  • Steel handles are the toughest, and are often fitted with a rubber grip.

How to replace a hammer handle

  1. Remove the old handle. Saw off the broken shaft close to the head, then drill out the stub in the eye and drive out the pieces.
  2. Clean the eye of the head and check it for cracks. Don’t reuse a cracked head.
  3. Choose a new handle of the right size and length for the head.
  4. Fit the handle into the eye, rasp or sand it to a snug fit, and tap it with the head’s weight so it seats fully.
  5. Saw a slot in the top end if the handle has none, then drive in a wooden wedge across the grain.
  6. Add a steel wedge for extra grip, cut off the extra handle and wedge flush with the head, and finish the grip.

Safety

Wear safety glasses when driving wedges or hammering. A loose head can fly off, so inspect hammers before use, check that the head sits tight on the handle and replace any handle with cracks or splits.

Related guides: sheet metal hammers, ratcheting wrench sets and how to read a tape measure.

Frequently asked questions

What is the face of a hammer?

The flat or slightly domed striking surface of the head. On framing hammers it can be waffled for grip on nails.

What is the claw of a hammer for?

Pulling nails. A curved claw gives leverage for pulling, and a straight (rip) claw is also used for prying and light demolition.

How long should a sledgehammer handle be?

Common lengths are about 24 to 36 in (60 to 90 cm), shorter for one-hand and short-swing work and longer for full swings. Choose the handle length that matches the head and your reach.

Can I fix a loose hammer head?

Re-seat it by driving in a new wedge, or replace the handle. A loose head can fly off, so don't use the hammer until it is fixed.

Report a mistake on this page