SDS-Plus vs SDS-Max Hammer Drills: Which One

SDS-plus uses a 10 mm shank and suits holes up to about 1 in in concrete and masonry, with a lighter, cheaper rotary hammer. SDS-max uses an 18 mm shank for larger holes, chiseling and demolition, with a heavier, more powerful tool. Bits are not interchangeable, so buy the tool that matches the work.

SDS-plus vs SDS-max at a glance

FeatureSDS-plusSDS-max
Shank diameter10 mm18 mm
Typical hole sizesAbout 5/32 to 1-1/8 inAbout 1/2 to 1-3/4 in and up
Tool weightLighterHeavier
Impact energyLowerHigher
ChiselingLightHeavy breaking and demolition
PriceLowerHigher
Typical userHomeowner, installerContractor, demolition crew

Makers differ, so check the tool’s rated capacity for each material.

When SDS-plus is enough

Anchor holes, wall plugs, conduit holes and light chiseling in concrete and brick all suit SDS-plus. The tool is easier to hold overhead. For bit choice, see masonry drill bits.

When you need SDS-max

Large core holes, deep holes, chasing and breaking concrete need the extra impact energy of SDS-max. The tool weighs more, so use the side handle and brace the work.

SDS vs a hammer drill

A hammer drill uses a standard chuck and a clutch-based hammer action. An SDS rotary hammer uses a piston mechanism that hits harder and drills concrete much faster. See hammer drills for the difference and which drill bits fit which drills for the shank fit table.

How to choose

  1. List the largest hole you will drill. Up to about 1 in suggests SDS-plus.
  2. Think about chiseling or demolition. Heavy work suggests SDS-max.
  3. Consider weight and budget, since SDS-max tools are heavy and cost more.
  4. Check that bits in your size are available for the system you pick.

Safety

Wear safety glasses, hearing protection and a dust mask, since concrete dust contains silica. Use the side handle and hold the tool firmly, because it can kick when the bit binds.

Frequently asked questions

What does SDS stand for?

The name is usually explained as Steck, Dreh, Sitz in German (insert, twist, stay), though other explanations are quoted. It names the tool-holding system, not a power rating.

Can I use SDS-plus bits in an SDS-max drill?

Not directly, since the shanks differ. Adapters exist, but they add play and are not meant for hard use.

Which is better for home use?

SDS-plus. It handles anchor holes and small chiseling jobs in concrete, and the tool is lighter and cheaper.

What size holes does an SDS-max drill?

Larger holes, often from about 1/2 in up to around 1-3/4 in or more, plus heavy chiseling and breaking. Check the tool's rated drilling capacity.

Report a mistake on this page