Sheet Metal Hammers: Planishing, Bumping and Body Hammers

Sheet metal is shaped with a hammer and a dolly: a planishing hammer smooths and stretches, a bumping hammer knocks out dents against a dolly, a pick hammer raises small low spots, and a cross peen hammer works edges and seams. Use mallets of rawhide, nylon or wood on aluminum and other soft metals, and polished steel hammers on steel.

Sheet metal hammer types at a glance

HammerFaceBest for
PlanishingSmooth, flat or slightly domedSmoothing and finishing a panel
Bumping (body)Wide, crowned, with a flat or round endRough shaping, removing dents with a dolly
PickPointed end and a flat or round faceRaising small low spots from behind or in front
Cross peenWedge-shaped peen across the headEdges, seams and corners
ShrinkingSerrated or cross-hatched faceGathering metal to shrink a stretched area
Mallet (rawhide, nylon, wood)Soft, non-marking faceSoft metals, folding sheet, shaping over forms

Hammers differ by maker and region, so names vary. Choose by what the face does to the metal.

Hammers and dollies

A dolly is a hand-held block of steel held behind the panel. A hammer strikes the metal against the dolly, which squeezes and flattens it. Common dolly shapes are flat for flat areas, curved for crowns and a spoon shape for leverage in tight spaces. Hammer on the dolly (on-dolly) to flatten a high spot and next to it (off-dolly) to raise a low one.

How to remove a dent

  1. Clean the panel and decide where the dent sits relative to the panel’s shape.
  2. Work from the outside edge of the dent toward the center, with light blows.
  3. Hold a dolly behind the high spots and hit the metal against it.
  4. Move the dolly behind the low spots and hit beside them to push them up.
  5. Check the surface by running a hand lightly over it, and stop before the metal stretches.

Tips

  • Keep the hammer and dolly faces smooth and free of rust. Dents and scratches in a face are printed onto the panel.
  • Use steady, even blows. Hard hits stretch the metal.
  • Anneal or heat sparingly, and only as the metal requires. Aluminum behaves differently from steel and work-hardens quickly.
  • Wear safety glasses and hearing protection.

For other hammer types, see types of hammers, and for cutting sheet, see best saw for cutting metal.

Frequently asked questions

What is the difference between a planishing hammer and a bumping hammer?

A planishing hammer has a smooth, flat or slightly domed face and is used to smooth and finish a surface. A bumping hammer has a wider, crowned face and is used to roughly shape a panel and knock out dents, often against a dolly.

What is a dolly used for in sheet metal work?

A dolly is a hand-held steel block held behind the panel. The hammer strikes the metal against the dolly, which shapes it and flattens high spots.

What hammer for aluminum sheet?

Use a soft-faced mallet of rawhide, nylon or wood, or a hammer with a smooth, polished plastic face. Steel hammers can mark and work-harden aluminum.

Why does sheet metal stretch when I hammer it?

Each blow thins and spreads the metal. Overworking an area leaves a high, stretched spot. Use light, even blows, and shrink the high area if it grows.

Report a mistake on this page