Can I Cut Aluminum With a Chop Saw?
Yes, but it depends on which kind of “chop saw” you mean. A miter saw (often called a chop saw) cuts aluminum cleanly when fitted with a carbide-tipped blade made for non-ferrous metal. An abrasive chop saw, the kind with a 14-inch cut-off wheel for steel, is a poor choice: soft aluminum clogs the wheel, which then cuts slowly, overheats and can fail. Dry-cut metal saws with carbide blades can cut aluminum if the blade is rated for it.
Which saw and blade to use
| Saw | Blade | Aluminum? |
|---|---|---|
| Miter saw (wood chop saw) | Carbide non-ferrous blade: many teeth, triple-chip grind, negative or low hook angle | Yes; the usual choice for extrusions, angle, tube and trim |
| Abrasive chop saw | Abrasive cut-off wheel | Not recommended; aluminum loads up the wheel |
| Dry-cut metal saw (cold saw) | Carbide blade rated for aluminum | Yes, with the right blade |
| Circular saw or table saw | Carbide non-ferrous blade rated for the saw | Yes, for sheet and plate, with care |
A non-ferrous blade’s negative or low hook angle stops the teeth grabbing the soft metal and pulling the saw into the cut, and the triple-chip teeth shear aluminum cleanly. A general-purpose wood blade with a steep positive hook is more likely to grab and throw chips.
How to cut aluminum on a miter saw
- Fit a non-ferrous blade of the diameter and arbor size the saw specifies, rated for at least its RPM.
- Clamp the piece firmly against the fence and table. Aluminum is light and the blade will try to move it.
- Support long pieces level with the table on both sides, so the offcut doesn’t drop and pinch the blade.
- Let the blade reach full speed, then feed down slowly and steadily. Thin-wall tube and angle need an especially slow feed.
- Lubricate the blade with a stick wax or a cutting fluid made for aluminum, so chips don’t weld to the teeth.
- Let the blade stop before raising it, then deburr the cut edge with a file.
Wear safety glasses and hearing protection; aluminum chips are sharp and are thrown out hot. Clean the chips out of the saw afterward, especially before cutting wood again.
What size can you cut?
The limit is the saw’s cutting capacity, not the material. Solid bar and thick plate are slow and hard on the blade; extrusions, tube, angle and channel are what miter saws do well. For curves or cut-outs in sheet, use a jigsaw with a fine metal blade; 5 best jigsaw blades for metal cutting covers the blades. For steel, see best saw for cutting metal.
Related guides
Related guides
- Guide
Sliding vs Non-Sliding Compound Miter Saw
How a sliding and a non-sliding compound miter saw differ in crosscut width, space, weight and accuracy, and which one suits trim, framing or wide boards.
- Guide
Table Saw Fence: Types and How to Square One
The main table saw fence types, how to check and adjust a fence so it sits parallel to the blade, and why the fence must never double as a crosscut stop.
- Guide
Hacksaw: Blade TPI, Types and How to Use One
What a hacksaw is used for, which blade TPI (14, 18, 24 or 32) suits each metal, how to fit the blade, and how to cut straight without breaking blades.