Can I Use a Torque Wrench as a Breaker Bar?
You shouldn’t use a torque wrench as a breaker bar. A stuck or rusted bolt can need far more force to break loose than it was tightened to, and that force goes straight through the wrench’s measuring mechanism. On a click-type wrench it can bend or overload the internal spring and knock the calibration out, so every bolt you tighten afterward is wrong. Break the bolt loose with a breaker bar, spin it out with a ratchet, and keep the torque wrench for the final tightening.
Torque wrench vs breaker bar
| Torque wrench | Breaker bar | |
|---|---|---|
| Job | Tightens a fastener to a set torque | Loosens tight or seized fasteners |
| Inside | A spring and click mechanism, a beam, or a strain gauge | Solid steel bar, no mechanism |
| Load limit | The top of its scale | Far beyond a torque wrench of the same length |
| Ratchet | Usually ratcheting | Usually a flexible head, no ratchet |
| What overloading does | Shifts the calibration, can break the mechanism | Very little |
Why loosening is hard on a torque wrench
- Breakaway torque is higher than tightening torque. Rust, thread locker and heat cycles mean a bolt tightened to 100 ft-lb can take much more to start turning. A wrench that tops out at 150 ft-lb can easily be pushed past its limit.
- Shock loads. When a stuck bolt suddenly gives, the wrench takes a jolt that the click mechanism isn’t designed for.
- Many click wrenches only measure clockwise. Some can click counterclockwise for left-hand threads, but turning them hard counterclockwise is still outside what they’re meant for. The manual says which directions are calibrated.
A beam-type torque wrench has no spring, so it’s more forgiving, but the same rule applies: don’t pull past the end of its scale.
How to loosen a tight bolt the right way
- Use a six-point socket or wrench that fits snugly, so it grips the flats instead of rounding the corners. A ratcheting wrench is handy for spinning the nut off once it’s loose.
- Apply penetrating oil to rusted threads and give it time to soak in.
- Use a breaker bar, pulling smoothly. A longer bar gives more leverage; don’t add a pipe extension to a ratchet or torque wrench.
- Check the thread direction. Some fasteners are left-hand threaded and loosen clockwise; left-hand vs right-hand drill bits covers removing broken ones.
- For badly seized bolts, heat (on metal parts away from fuel and plastics) or an impact wrench may be needed.
Looking after a torque wrench
- Store a click wrench at its lowest setting, not under spring tension, and not below the bottom of the scale.
- Don’t drop it. A drop can shift the calibration.
- Have it checked about once a year or every 5,000 uses, whichever comes first, and after any drop or overload. Types of torque wrenches covers accuracy and calibration in more detail.
- Use it only for tightening, with the right socket and no extensions on the handle.
If you used a torque wrench to loosen something before and the readings now seem off, have it calibrated before relying on it again.
Related guides
Related guides
- Guide
Allen Wrench Sizes: Metric and SAE Hex Key Chart
Allen wrench (hex key) sizes in mm and inches, which key fits which metric and inch socket cap screw, and how close metric and SAE keys really are.
- Guide
Wrench Sizes: Metric to SAE Conversion Chart
Wrench size chart from 6 mm to 30 mm with the nearest SAE inch size, which pairs are close enough to swap, and the wrench size for common metric and inch bolts.
- Guide
Chain Wrench vs Oil Filter Wrench: Uses and Types
Chain wrench vs oil filter wrench: what each grips, the types of filter wrench (cap, band, three-jaw, strap), and which to use for pipes and filters.